Happymodel Larva X HD 125mm 3-4S Toothpick And Whoop 2 IN 1 FPV Racing Drone BNF - Frsky XM+ Receiver

General

Brand Name: Happymodel
Item Name: Larva-X HD Micro FPV brushless Drone 
Wheelbase: 125mm
Size: 105 x 105 x 35mm(without propellers)
Weight: Toothpick style ductless 63g (without battery)
             Whoop style ducted 79g (without battery)
Version: BNF
Receiver: Frsky XM+

Specification

Flight Controller:

(External RX version) CRAZYBEE F4 PRO V3.0 Firmware target: CrazybeeF4DX
MCU: STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: MPU-6000(SPI connection)
Board Size: 28.5 x 28.5MM
Power Supply: 2-4S battery input (DC 7-17V)
Built-in 10A(each) Blheli_S 4in1 ESC Dshot600 ready
Could add external receiver on the FC board
Built-in Betaflight OSD(SPI Control)
Built-in Current meter Max 70A
Current meter scale set to 470
Built-in 5V 1A BEC
Built-in voltage detection

Onboard 4in1 ESC

MCU upgraded to EFM8BB21
Power Supply: 2-4S LiPo/LiPo HV (7v/17v)
Current: 10A continuous peak 12A (5 seconds)
Support BLHeliSuite programmable
Factory Firmware: F_H_40_REV16_7.HEX
Default Protocol: DSHOT600

External Frsky XM+ version

Dimension: 21.5 x 12 x 3.5mm(L x W x H)
Weight: 1.6g
Number of Channels: Up to 16CH from SBUS (1-15ch for PWM,16ch RSSI for FC)
Operating Voltage Range: 3.7~10V
Operating Range: Full range
With RSSI Output on Board: Analog 0~3.3V
Antenna: 10cm
Firmware Upgradeable
Compatibility: FrSky D16 mode

VTX

Output Power: 25~200mw switchable
Frequency: 40CH
Input Voltage: 3.3V 5.5V
Current Consumption: 300mA(type)
Antenna: Micro UXII Antenna
Frequency: 5.8GHz 5bands 40 channels
With Race band 
Smartaudio ready
Weight: 3g

Caddx Baby turtle Cam

TV System: NTSC/PAL changeable
Video Resolution: 1080P@60fps / 1080P@30fps / 720@60fps
Power Input: DC 4.5-20V
Mini Illumination: 0.01lux
Image Resolution: 2 Megapixels
Working Current: 380mA@5V/160mA@12V (low consumption)
OSD Menu: Yes (Support Voltage Display)
Video Files: MP4
Audio: Support
Electronic Shutter : PAL : 1/50-100,000 NTSC : 1/60-100,100
S/N Ratio: >60dB (AGC OFF)
Video Output: CVBS
Max Micro SD Card Supported: 8-64GB(need Class 10 or above, recommend Class 10/UHS-I/UHS-II)

Motor

Mode: EX1203 KV6200
Configu-ration: 9N12P
Stator Diamter: 12mm
Stator Length: 3mm
Shaft Diameter: Φ1.5mm
Motor Dimension(Dia.*Len): Φ15mm*15mm
Weight(g): 4.7g
No.of Cells(Lipo): 2S-3S

Lipo Battery

Capacity: 450mAh
Voltage: 11.4v
Continuous Discharge Rate: 75C
Size: 66mm x 21mm x 18mm
Weight: 42g
Connector: XT30

Weight & Dimensions

Product Weight: 79g

Product Size (L x W x H):  105 x 105 x 35mm

Package Contents

1 x Larva-X HD frame (with Toothpick style canopy and Whoop style canopy)
4 x Whoop ducts for Larva-X HD
1 x Frsky XM+ receiver
4 x EX1203 KV6200 brushless motors
1 x Propeller sets
1 x CADDX Baby turtle
1 x VTX 5.8g 25mw~200mw switchable 
2 x 3S 11.1v 450mah 75c Li-po batteries
1 x 5.8g Micro UXII antenna
1 x Propeller disassemble tool